+- MinimServer Forum (https://forum.minimserver.com)
+-- Forum: MinimServer (/forumdisplay.php?fid=1)
+--- Forum: MinimServer 2 (/forumdisplay.php?fid=12)
+--- Thread: Minimwatch greyed out after NAS password change (/showthread.php?tid=6117)
Minimwatch greyed out after NAS password change - Steeve - 17-03-2021 20:14
Hi
I had been using Minimwatch successfully on my Windows 10 PC and now today it has gone into 'greyed out' mode where the only options available are Options, Refresh and Exit. I can still access Minimserver fine from the NAS and from my uPnP software on my Naim streamer.
The only change that I'm aware of - other than automatic Windows upgrades - is that I changed the sign-in password for my QNAP HS251 NAS. After this I had to reconnect the mapped drives on my PC so I'm wondering if this has also affected Minimwatch in some way. Unfortunately I can't set it back to the old password to check as the QNAP software has since tightened up its password requirements and it isn't valid any more!
Any advice please? I wanted to avoid reinstalling Minimwatch if possible as I didn't want to lose my settings.
Thanks
Steve
RE: Minimwatch greyed out after NAS password change - simoncn - 17-03-2021 21:06
This is not caused by your password change.
Are there any messages in the MinimWatch log? To view this, select Options > Show log (watch).
RE: Minimwatch greyed out after NAS password change - simoncn - 17-03-2021 21:49
If Windows has recently installed a Java update, this could be the cause of the problem. This often leaves the Windows firewall in a state where inbound connections to Java (and MinimWatch) are blocked. For information about how to update the firewall configuration, see the MinimWatch can't find MinimServer section.
RE: Minimwatch greyed out after NAS password change - Steeve - 17-03-2021 22:32
Thanks for the replies. This is the content of the log set at Info level:
MinimWatch 0.8.5.3 update 64, Copyright © 2012-2019 Simon Nash. All rights reserved.
Java™ SE Runtime Environment (build 1.8.0_221-b11)
Java HotSpot™ 64-Bit Server VM (build 25.221-b11, mixed mode)
Platform default charset is windows-1252
Using single subnet 192.168.1.0
Startup complete
I will check out the other thing about Java.
Thanks
Steve
RE: Minimwatch greyed out after NAS password change - Steeve - 17-03-2021 22:48
Hi again
I tried turning Window Defender Firewall, which I normally use, off and rebooted my PC but I still got the same result.
Steve
RE: Minimwatch greyed out after NAS password change - simoncn - 17-03-2021 22:50
I see you have set a custom value for ohnet.subnet. Are you sure this is correct? What is the IP address of your NAS?
RE: Minimwatch greyed out after NAS password change - simoncn - 17-03-2021 22:50
If the Windows network type has changed from private to public, this could cause the problem.
RE: Minimwatch greyed out after NAS password change - Steeve - 17-03-2021 23:03
It's ok I've solved it. I've updated Minimwatch to the latest version. Could have sworn Minimwatch was working after the upgrade of Minimserver to version 2 but reread all the notes and these suggest it doesn't!
Still, all good now - thanks for your time.