Minim Setup

[Peter StreamMagic]

(11-09-2015 10:35)simoncn Wrote:  

(11-09-2015 08:49)LAntony Wrote:  Hi Simoncn, thank you for the reply. Yes I have the ethernet streaming board fitted and the C1 is connected to the router via an ethernet cable. I also have an Android device running the CH control app.

The issue appears to be that the UPnP control point or app, cannot see the C1 and visa versa. But the app can see the MinimServer on my Macbook - which implies that the server and the app are functional on the same network, but the C1 is not.

The router from which the C1 and the Macbook and the app are running is actually setup as an access point, it is downstream of a router which is on the other side of the building and linked via ethernet cable.

It sounds like you have the right components in place but something isn't set up correctly to allow other network devices to access the C1 using multicast. This problem might be in your network setup or it might be in your configuration settings for the C1. It is probably best to start by contacting CH to confirm that you have the correct settings in the C1. They should also be able to advise you on possible network issues that could cause this problem.

You probably have use the announce setting in the network menu.
This forces the C1 to send messages to announce itself, it makes it possible other devices to detect the C1.
Just being curious, you paid a huge amount of money for a streamer, I would expect your dealer to completely install this nice device!!

Peter