MinimServer Forum / MinimServer / Support v / Minimwatch stopped working immediately as scanning was completed

Post Reply 
Minimwatch stopped working immediately as scanning was completed
08-12-2019, 18:25 (This post was last modified: 08-12-2019 18:27 by echable.)
Post: #9
echable Offline
Junior Member
**
 		Posts: 13
Joined: Nov 2019
Reputation: 0
RE: Minimwatch stopped working immediately as scanning was completed
Minimwatch is on WIN10 10, Minimserver is on Synology NAS.

Minimwatch used to stay grey, not it stays red.

I have checked through Synology's interface which subnet is on. When I enter this into Minimwatch, it says subnet not found.

Router is ASUS RT 87-U with Merlin firmware
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Minimwatch stopped working immediately as scanning was completed - echable - 08-12-2019 18:25

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | MinimServer Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication