MinimServer 2 on Synology: Format Error

[LittleScarabee]

Thanks for your answer.

(11-05-2020 10:35)simoncn Wrote:  MinimServer does not sleep unless the machine that it is running MinimServer has gone into a sleep mode controlled by the operating system.
...
If the machine running MinimServer has gone into sleep mode, the machine may have "wake on LAN" enabled which causes it to start running when it receives a "rescan" request from the configuration web page. If this is the case, clicking "Refresh status" on the configuration web page should also be sufficient to make MinimServer show in BubbleUPnP.

Application is installed on my NAS with no standby on Hard Drive and I never had this type of issue with the previous version (i.e. 0.8.5.3). The difference is :
* MinimServer v2.0 : Used via Synology Packages
* MinimServer v0.8 : Used via Docker (on the same NAS)

(11-05-2020 10:35)simoncn Wrote:  ...
Does MinimWatch see MinimServer after you have done the rescan? If it does, this problem with the MinimWatch icon being grey is probably caused by the machine running MinimServer having gone into sleep mode. If MinimWatch does not see MinimServer at all, this is likely to be caused by a network or firewall issue. See this page for possible causes and how to solve them.
..

For your information I got the same issue after not used MinimServer after around 2 hours...since my last message. As I got the issue again :
* MinimWatch did not saw the server after launch again a scan via Web page.
* After gone on my NAS in "Packages Center" I saw I did not selected the option "trust in all editors". After selected this option and "do not install beta version" : MinimWatch see automatically the server.

I keep you posted if the root cause was on these settings (to help other people)

Thanks