MinimServer not working after cloning hard drive

[simoncn]

The location (IP address) of the Melco is shown on the front panel of the Melco. If no IP address is shown there, this means your Melco does not have a network connection. A network failure could explain the other problems you are seeing. As a first step, I suggest you power the Melco off and on again. If this doesn't help, power off all your devices including your network router and any switches, then power them on again.

Cloning the hard drive can cause problems with MinimServer. Please explain exactly what you have done with the cloned copy and the original copy of the hard drive. For example, are these two hard drives in different computers that are both running at the same time, have you replaced the original hard drive with the cloned copy?