Auto Start After Update?

[simoncn]

(22-01-2015 12:01)Niko Wrote:  Thank you for your prompt reply.

I manually downloaded MinimServer 0.8.3, did a manual install and after starting it I found it is on update 57. Interested in what should happen after a NAS reboot I tried this as well, and - MinimServer auto-started after reboot had finished. This is as well a further improvement.

Now until MinimServer quits again for not obvious reasons, and if it does not, I think we can consider this issue as solved.

OK, this sounds good.

Quote:By the way, a found a small problem which I could solve on my own, but less experienced users may want to have this mentioned also in your installation instructions: If the package was downloaded manually from your web site, after starting the update and before the licence agreement is displayed, there might be a message displayed that the software has no signature, and the only option you have is to abort from the update.

In this case, the user should change the "confidence level" in Package Center under "General" to the last entry meaning "Any publisher" (or so - don't know which English term is used there since I am using the German version of QTS), which may be changed back to the previous setting after successful installation.

Once more, thank you for your support - you did what Synology's support center failed to do.

This is already mentioned in point 4 of the "Installing or updating MinimServer" section on this page.